18
TX-3
INSPECTION & START-UP
LINEAR GUIDE BAR ADJUSTMENT
A combination square is needed for 45º adjustment. This adjustment is to ensure consistency of material cutting
width.
1.
2.
3.
Loosen Guide Bar Adjustment Screws (N) on front and rear End Caps (O).
Tap Guide Bar lightly until Table Fence (P) is perpendicular with the blade by using a combination square.
Tighten up Screws and re-check that the Blade is square with the Table Fence (P).
P
O
N
Summary of Contents for TX-3
Page 28: ...28 TX 3 MAINTENANCE WIRING DIAGRAM ...
Page 48: ...48 TX 3 NOTE PAGE ...
Page 51: ...51 TX 3 NOTE PAGE ...