18
FIllING FUEl TANK
MK-20 SERIES SET-UP
WARNING
1. Gasoline is highly flammable and explosive. You can be burned or seriously
injured when handling fuel.
2. To fuel, stop engine if running, and allow it to cool.
3. Fuel in a well-ventilated area.
4. Keep gasoline away from appliance pilot lights, barbeques, electric appliances,
power tools, etc.
5. Wipe up spills immediately. Do not start engine until spill is dry.
6. When filling the fuel tank do not overfill. Always leave enough area for
expansion due to environmental heating.
1. Fuel can damage paint and plastic. Be careful not to spill fuel when filling the
fuel tank. Damage caused by spilled fuel IS NOT covered under the warranty.
2. DO NOT use stale or contaminated gasoline, or an oil/gasoline mixture.
NoTE:
(A)
Remove the Fuel Cap.
(B)
Ensure fuel level is 1” below the
throat of the Fuel Tank.
1 inch (25mm)
from throat
Maximum Fuel
Level
FRoNT PoINTER AlIGNMENT
The Front Pointer is set in line at the factory. However, the pointer should be checked for proper
alignment with the blade after every use.
(A)
Using a straight edge, care-
fully mark a line 12 feet long on
a smooth level concrete surface.
Place Saw parallel to line; lower
Blade and center it over the line.
(B)
With the Blade centered over the
line and the Saw Frame parallel
to the line, lower the front Pointer
assembly and position the pointer
over the line.
(C)
Adjust the Pointer in or out if the
orange wheel is off the line by loos-
ening the thumbscrew on the end of
pointer. Align orange wheel with line
and tighten thumbscrew. Roll saw
along the entire length of the line to
ensure proper alignment.
Summary of Contents for MK-2013HE GX390
