OPERATION
17
EN
into the torch receptacle. Check that the drive roller size is compatible with the wire diameter, replace
the roller if necessary.
(9) Align the wire into the groove of the drive roller and close down the top roller making sure the
wire is in the groove of the bottom drive roller, lock the pressure arm into place. Apply a medium
amount of pressure to the drive roller.
(10) Remove the gas nozzle and contact tip from the torch neck.
(11) Pull the trigger to feed the wire through to the torch neck, release the trigger when the wire exits
the torch neck.
(12) Fit the correct sized contact tip and feed the wire through it, screw the contact tip into the tip
holder of the torch head and nip it up tightly.
(13) Fit the gas nozzle to the torch head.
(14) Carefully open the gas cylinder valve and set the required gas flow rate.
(7) Place wire onto spool holder - (spool retaining (8) Feed wire over the drive roller into
nut is left hand thread ) Feed the wire through the the outlet guide tube, Push the wire
inlet guide tube on to the drive roller. through approx 150mm.
(9) Close down the top roller bracket and clip (10) Remove the gas nozzle and contact
the pressure arm into place with a medium tip from the front end of the mig torch.
amount of pressure applied.
Summary of Contents for Multi-GMAW 200 LCD PFC
Page 24: ...23 DE 12 WIG Stecker Belegung EIN AUS 10K Poti zum Reglen des Schwei stromes Stecker Belegung...
Page 25: ...24 DE 13 Spool GUN Stecker Belegung EIN AUS Taster Strom Regler Stecker Belegung...
Page 29: ...28 DE 17 Schematischer Schaltplan Multi GMAW 250 LCD PFC 230V...
