MK Welding Multi-GMAW 200 LCD PFC, User Manual

Page: 101 / 104

70
EN
power light isn’t on
Fuse damaged Change it
Input power damaged Change it
2
After welding machine is
over-heat, the fan doesn’t
work
Fan damaged Change it
The cable is loose Screw the cable tight
3
Press the
gun
switch, no
output
shielded
gas
No output
gas when
test gas
No gas in the gas cylinder Change it
Gas hose leaks gas Change it
Electromagneticvalve
damaged
Change it
Output gas
when test
gas
Control switch damaged Repair the switch
Control circuit damaged Check the PCB
4
Wire-
feeder
doesn’t
work
Wire reel
doesn’t
work
Motor damaged Check and change it
Control circuit damaged Check the PCB
Wire reel
works
The press wheel is loosen or
weld wire skids
Press it tightly again
The wheel doesn’t fit with
the diameter of weld wire
Change the wheel
Wire reel damaged Change it
Wire feed pipe is jammed Repair or change it
Tip is jammed because of
splash
Repair or change it
5
No striking arc and no
output voltage
Output cable is connected
incorrectly or loosen
Screw it down or change it
Control circuit damaged Check the circuit
6
Welding stops, and alarm
light is on
Machine has self-protection
Check over-voltage, over-current,
over-temperature, lower-voltage
and over-temperature, and solve it
7
Welding current is run
away and can be not
controlled The potentiometer damaged Check or change it
The control circuit
damaged
Check the circuit
8
The crater current can be
not adjusted
The PCB damaged Check it
9 No post-gas The PCB damaged Check it