13
THIRD ANGLE PROJECTION
1
2
4
3
6
7
8
9
10
11
12
13
8
14
5
5
4
3
1
Folder
S:\Solidworks\Solidworks_Elo\Cutter\15' Pulsar Bat Wing\35014.SLDASM
DWG. NO.
REV
Model
SCALE 1:96
SHEET 5 OF5
DATE DRAWN
MATERIAL
35014
September-21-16 10:47:28 AM
DESCRIPTION
15 Pulsar Cutter Assembly
S:\Solidworks\Solidworks_Elo\Cutter\15' Pulsar Bat Wing\
Weight(lbs.)
0
Width
Height
Length
0
0
4202.13
0
Blank Size
Unit of Measure
ITEM ID.
35014
Config ID
Assmy in
DIMENSIONS ARE IN INCHES
TOLERANCES NON SPECIFIED:
FRACTIONAL 1/64
BEND 1.0
TWO PLACE DECIMAL 0.01"
THREE PLACE DECIMAL 0.002"
Notes
DO NOT SCALE DRAWING
WARNING
!
Always block cutter securely before working on or under cutter.
Assembly Information
Leveling center Deck and Wings
These adjustments should be made with your cutter hooked to the tractor operating the unit or
to a tractor having the same drawbar height.
1. With cutter attached to a tractor, disengage PTO, and park on a level, hard surface. Place
tractor gear selector in park or set park brake.
2. Wait for blades to come to a complete stop and then fold wings up to transport position.
3.
Using hydraulic lift, adjust center deck height so that front skids are 2 to 3 inches above
ground.
4. Shut tractor engine off and remove switch key before dismounting from tractor.
5.
On both sides of the center deck are continuous hinges. Measure distance from bottom of
hinges to ground at the front and back. They should be equal distance off the ground at the
back and 1” closer to the ground at the front than they are at the back.
If continuous hinges are too high at the front:
Loosen Couplers (#6) an equal amount to lengthen both leveling rods until hinges are in-
clined from front to back by 1” with the front being closer to the ground than the back.
If continuous hinges are too low at the front:
Tighten Couplers (#6) an equal amount to shorten both leveling rods until hinges are in-
clined from front to back by 1” with the front being closer to the ground than the back.
6. Be sure both sides are equal distance from ground to continuous hinges and that left and
right leveling rods have equal tension. Re-tighten jam nut.