CHAPTER 4
STEERING CONTROL SYSTEM
- 17 -
29z
Volvo EVC Display
EVC Control Panel
Power Trim Control
Panel
Anchor Lt. Switch
Wiper/Washer
Bow Thruster Joy
Stick
Spotlight Control
Thruster(s) Emergency
Push to Disconnect
Auto Bilge Pumps
Horn Buttton
GPS Plotter/Radar
Engine Start/Stop
ST40 Depth
Trim Tabs (Optional)
FireBoy System
Battery Parallel Switch
4.1 GENERAL
The helm control console is where most of the operation controls of the boat are located. Become
familiar with these before you need to use them. You don’t want to be looking for your glasses
and a flashlight while trying to turn on the bow-thruster at night! In addition, make sure that when
you are using the boat, even if you are not using a specific piece of equipment, that the circuit
breakers are on for any equipment you
might
need. Again, you don’t want to be searching for a
breaker when you need something in a hurry.
4.2 STEERING
Steering of the 29z is by power assisted hydraulic system that directs the stern drive. There is no
rudder. Like an outboard engine,the thrust of the propeller can be directed from side to side.
4.3
POWER TRIM CONTROL PANEL
Activate by turning on the ignition then PUSH the “KEY” button
on the EVC Control Panel. The current position (angle) of the
drive can be shown on the EVC Disp lay. If not, PRESS button 2
of the display until “lower window” mode opens. Then turn the
ENTER/Toggle knob to “Trim Angle”. Push same ENTER/Toggle
knob to accept.
To RAISE the Bow (and to lift the drive up) PRESS “Up Arrow”
To LOWER the Bow ( and lower the drive) PRESS “Down Arrow”
Emergency Trimming
. If a fault prevents the trim panel from working, PRESS & HOLD the
BACK button (--) on the EVC Control Panel then trim the drive using the Trim Panel.