3. Operation Instructions
-The moving head is for beam light use.
-Don’t turn on the fixture if it’s been through severe temperature difference like after
transportation because it might damage the light due to the environment changes.
So make sure to operate the fixture until it is in normal temperature.
-This light should be keep away from strong shaking during any transportation or
movement.
-Don’t pull up the light by only the head, or it might cause damages to the
mechanical parts.
-Don’t expose the fixture in overheat, moisture or environment with too much dust
when installing it. And don’t lay any power cables on the floor. Or it might cause
electronic shock to the people.
-Make sure the installation place is in good safety condition before installing the
fixture.
-Make sure to put the safety chain and check whether the screws are screwed
properly when installing the fixture.
-Make sure the lens are in good condition. It’s recommended to replace the units if
there are any damages or severe scratch.
-Make sure the fixture is operated by qualified personnel who knows the fixture
before using.
-Keep the original packages if any second shipment is needed.
-Don’t try to change the fixtures without any instruction by the manufacturer or the
appointed repairing agencies.
-It is not in warranty range if there are any malfunctions from not following the user
manual to operate or any illegal operation, like shock short circuit, electronic shock,
lamp broke, etc.
.3.
8. Menu Instruction
DMX Address
A001-A512
Channel Mode
11/16CH Choose
Show Mode
Sound Mode/Auto Mode
Slave Mode
Master/Slave Mode Choose
Black Out
YES/NO Wait Mode
Sound State
ON/OFF
Sound Sense
0-100
Pan Inverse
YES/NO
Tit Inverse
YES/NO
Back Light
ON/OFF of display light
White Balance
LED1234 dimming
Manual Test
Pan,Tilt, LED1---4,Dimmer,Strobe
Auto Test
Auto run
Fixture Time
0-9999 fixture used time
Firmware Version
V104
Pro Defaults
YES/NO
System Reset
YES/NO
.8.
