2. Safety Instructions
This device has left the factory in perfect condition. In order to maintain this condition
and to ensure a safe operation, it is absolutely necessary for the user to follow the
safety instructions and warning notes written in this user manual.
If the device has been exposed to temperature changes due to environmental
changes, do not switch it on immediately. The arising condensation could damage the
device. Leave the device switched off until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device be
earthed.
The electric connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this
manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would
be the case, replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Only handle the power cord by the plug. Never pull out the plug by tugging the power
cord.
During initial start-up some smoke or smell may arise. This is a normal process and
does not necessarily mean that the device is defective, it should decrease gradually.
Please don't project the beam onto combustible substances.
Fixtures cannot be installed on combustible substances, keep more than 50cm
distance with wall for smooth air flow, so there should be no shelter for fans and
ventilation for heat radiation.
If the external flexible cable or cord of the luminaire was damaged, it shall
be exclusively replaced by the manufacturer or his service agent or a similar qualified
person in order to avoid a hazard.
.2.
9. DMX CHANNELS:
1 6CH M ode
Channel
Function
DMX Value
Description
1
Pan
0-255
0~540 degree
2
Pan fine adjustment
0-255
16bit
3
Tilt
0-255
0~270 degree
4
Tilt fine adjustment
0-255
16bit
5
Pan/Tilt speed
0-255
Pan/Tilt speed from fast to slow
6
X/Y Auto run effect
0-15
No function
16-35
Auto run 1
36-55
Auto run 2
..........
.........
236-255
Auto run 12
7
6CH Effect Speed
0-255
From fast to slow
8
Lens motor
rotation(Beam)
0-127
0-360 degree position
128-191
Rotation clock from fast to slow
192-255
Rotation re clock from slow to fast
9
Color Plate
0-67
16 kinds color and half color
68-128
Color Plate position 360 degree
120-190
Rotation clock from fast to slow
191-193
Stop
194-255
Rotation re clock from slow to fast
10
Macro function
0-69
No Function
70-79
Dark activate when X/Y Rotation
80-89
Dark no-activate when X/Y Rotation
90-199
No Function
200-209
Reset
210-249
No Function
250-255
Random Sound Mode
11
Total Dimming
0-255
Total Dimming 0-100%
12
Strobe
0-15
Open Lighting
16-131
Strobe from slow to fast
132-139
Open lighting
140-181
Fast dark then slow light
182-189
Open lighting
190-231
Slow light then fast dark
232-239
Open lighting
240-247
Random strobe
248-255
Open lighting
13
led1 dimming
0-255
Linear dimming from dark to bright
14
led2 dimming
0-255
Linear dimming from dark to bright
15
led3 dimming
0-255
Linear dimming from dark to bright
16
Led4 dimming
0-255
Linear dimming from dark to bright
.9.
