Mixpresso ST-503A, Instruction Manual

Page: 7 / 16

Fill/refill water tank
Filling by removing the
water tank
–hold the water grip at
tilting angle as shown in
direction 1 to remove
the water tank from the
machine.
– Fill the tank up to the
“MAX” mark with cold
fresh water (the
maximum capacity is
0.8 litre). or at least the
“Min” mark .
– slide the water tank slowly on water tank base, when the water
tank outlet is inserted in the inlet receptacle, pushing firmly on
the water grip as shown in direction 2 to lock the water tank .
Flushing out the machine and internal piping
Fill water tank to maximum level.
Plug in the appliance and turn it o n.
the lights on the control buttons are
blinking , the lights in used-capsule
container is lighted in blue which
goes off after 1 minute .
Tips: you can check easier if the
used container is full or not when
the blue light is on.
The lights at buttons become
steady when the machine is heated
up, heating up time is 45 seconds
approximately.
Before using for the first time or after long
pauses (e.g. holidays) the machine must be
flushed out
. This short procedure can flush
out and cleans the internal piping thoroughly.
There are two ways to fill the water tank:
directly into the machine, by using for
example a jug, or by removing the water
tank.
Filling without removing the tank
– raise the water tank lid
– Fill the tank up to the “MAX” mark with cold fresh water (the
maximum capacity is 0.8 litre), or at least the “Min” mark .
1
2
6