8-15
Chapter 8 PERIODIC INSPECTION AND MAINTENANCE PROCEDURES
Governor Oil Filter - Change
1.
Prepare a drip pan and place it under the governor
oil filter.
2.
Loosen the air vent plug and remove the drain plug.
Drain oil from the filter into the drip pan.
3.
Remove the oil pipe from the center bolt.
4.
Remove the center bolt and remove the case from
the bracket. Remove the used element from the
case.
5.
Put a new element in the case using the center
bolt.
6.
Install the case to the filter bracket. Tighten the
center bolt.
7.
Install the oil pipe to the center bolt.
8.
Install the drain plug.
9.
Remove the air vent plug. Fill up the filter with en-
gine oil.
10.
After filling up, reinstall the air vent plug.
Fig. 8-17 Governor oil filter - Drain
Fig. 8-18 Governor oil filter - Change
Oil Pipe - Inspect
Oil Pipe and Clip - Inspect and Replace
Visual Inspection at Overhaul
Loosen clamp fixing bolt and check clip wear and pipe
wear. If defective, replace the pipe assembly with a
new one.
In Every Other Major Overhaul
Replace the pipe assembly with a new one.
Fig. 8-19 Oil Pipe and Clip - Inspect and Replace
When draining oil or changing the oil filter, wear
gloves. Hot engine oil and parts may cause burns.
Air vent plug
Drain plug
Oil pipe
Center bolt
Element
Case
Clamp
Clip
