REASSEMBLY OF BASIC ENGINE
7-9
2.4 Installing oil pan
Clean the both side of the oil pan gasket contact surfaces
and the contact surfaces of other parts thoroughly.
(1)
Apply the sealant (ThreeBond 1212) to the mating
surface clearance of the No,1 and 4 main bearings and
crankcase.
The filling amount should be approx. 5 mm protruding
from the mating surface clearance, and enough to spill
out when the oil pan gasket is installed.
(2)
Install the oil pan gasket to the crankcase under face,
with pushing the gasket circular part into the No,1 and
4 main bearing cap grooves and pushing the gasket
protrusion into the mating surface clearance where
sealnt is filled.
(3)
Install the oil pan, and tighten the bolts to the specified
torque.
Installing oil pan
2.5 Inverting crankcase
&$87,21
Do not place the engine directly on the ground. It
causes cracking the oil pan.
(1)
Attach the wire rope to the crankcase. Using a crane,
hoist the crankcase and lay it with its side faced
downwards.
(2)
After that, hoist the crankcase again and invert it.
Inverting crankcase
8 ± 1 N·m
{0.8 ± 0.1 kgf·m}
[6 ± 0.7 lbf·ft]
Fill with ThreeBond
Approx.
5 mm
[0.20 in.]
