Mitsubishi PLK-E1008H Technical Manual Download Page 5

Page: 5 / 60

STANDARD ADJUSTMENT

··············································································· 22

7-1. Adjustment of the shuttle ·················································································· 22
7-2 Adjustment of the position between the needle and the shuttle ························ 22
7-3 Adjustment of the needle bar height ·······························································

7-4 Adjustment of the needle-to shuttle clearance ·················································

7-5 Adjustment of the needle-to-driver clearance ··················································· 24

7-6 Test mode operation ························································································

7-7 Adjustment of the presser foot ·········································································

7-7-1 Adjustment of the driving shaft arm(front) and the presser foot ············· 29
7-7-2 Adjustment of the sensor of the presser foot cylinder ···························· 30

7-8 Adjustment of the tension release ····································································· 30
7-9 Upper thread heat cut device ············································································· 31

7-9-1 Setting thread puller ··············································································· 31
7-9-2 Setting of the thickness detector ···························································

7-9-3 Setting of the thread wiper ······································································ 32
7-9-4 Adjustment of the upper thread heater ··················································· 32

7-10 Adjustment of lower thread cut heater ···························································

7-11. Adjustment of the bobbin winder ···································································· 35
7-12. Adjustment of the work holder pressure ························································· 35
7-13. Adjustment of the Thread take up spring tension ·········································

7-14. Adjustment of the position detecting disc ·····················································

7-15. Adjustment of the mechanical home position ···············································

7-15-1. Shifting the mechanical home position to the X direction ···················· 39
7-15-2. Shifting the mechanical home position to the Y direction ····················· 40
7-15-3. Fine adjustment of the mechanical home position in the X, Y direction ············ 40

7-16. Adjustment of the X-Y detector clearance ······················································ 41

7-16-1. Adjustment of the X detector clearance ··············································· 41
7-16-2 Adjustment of the Y detector clearance ················································ 41

7-17 Adjustment of the X-Y timing belt tension ······················································· 42

7-17-1 Adjustment of the X timing belt tension ················································· 42
7-17-2. Adjustment of the Y timing belt tension ················································ 43

BAD SEWING CONDITION & ITS CAUSE AND REMEDY

·························· 44

APPENDIX

·················································································································

1. Chart of connecting wires

··············································································

2. Wiring between the power switch to relay

····················································

3. I/O table

·············································································································

4. Trimming time chart

···························································································