Mitsubishi PLK-E1008H, Technical Manual

Page: 10 / 60

3-7 Connection of the foot switch
Connect the foot switch (NO. ) to the control box (NO. )
The foot switch is enclosed in the accessory box.
For the safety, please make sure
to carry the sewing machine head
by more than two people
.
Caution
3-8 Installation of the oil pan
(1) Assemble the oil pan
(2) (NO. ) and oil bottle (NO. ),
which are enclosed in the
accessory box.
(3) Insert the oil bottle (NO. ) into the
table top cut-out hole (NO. ),
which has much shorter distance
from the bottle center to the front.
(4) Install the oil pan (NO. ) parallel
with the table front edge.
(5) Fix the oil pan (NO. ) at its four
corners on the table top with four
staples (NO. ) en-closed in the
accessory box.
3-9 Installation of the sewing machine
head
(1) Make sure to hold the machine table with the caster stopper.
(2) Fit the rubber cushion pads (NO. ) into the each hole (NO. ) on the table top. The rubber
cushion pads (NO. ) are enclosed in the accessory box.
(3) Put the sewing machine head on the table top and set the each leg to the each rubber
cushion pad (NO. )
(4) Attach two hinges (NO. ) temporarily, make the set screws (NO. ) fastening with the thread
holes (NO. ) light, on the left side surface of the machine bed with the hexagonal socket
head set screws (NO. ).
(5) At this time, take notice of the E-shaped snap ring must be come to the front.
(6) These parts are all enclosed in the accessory box.
(7) Fit the screw holes (NO. ) of the hinges (NO. ) to the bolt setting holes (NO. ) on the table
top then, pass the bolt (NO. ) through these holes and fasten the bolt (NO. ) to fix the
hinges (NO. ) with the flat washers, the spring washers and the nuts (NO. ).
(8) Fasten firmly hexagonal socket head set screws (NO. ) which set the hinges (NO. )
temporarily at above procedure (4) then, fix the hinges (NO. ) perfectly.
(9) Insert the head (NO. ) into the hole (NO. ) on the table top.
5