45
ON/OFF
TEMP
FAN
VANE
MODE
CHECK
LOUVER
TEST RUN
AUTO STOP
AUTO START
h
min
TEST RUN
RESET
SET
CLOCK
6
4
A
5
2
3
<Before test run>
Measure an impedance between the power supply terminal
block on the outdoor unit and the ground with a 500 V Megger
and check that it is equal or greater than 1.0M
"
"
.
1
Turn on the main power to the unit.
2
Press the button twice continuously.
(Start this operation from the status of remote controller display
turned off.)
A
and current operation mode are displayed.
3
Press the ( ) button to activate mode, then
check whether cool air is blown out from the unit.
4
Press the button and check whether strong air is blown out
from the unit.
5
Press the button and check whether the auto vane operates
properly.
6
Press the ON/OFF button to stop the test run.
Note:
• Point the remote controller towards the indoor unit receiver
while following steps
2
2
to
6
6
.
• It is not possible to run the in DRY, AUTO mode.
MODE
COOL
TEST RUN
FAN
VANE
TEST RUN
PLH-3AK
1
.UK PLH-4, 5, 6AKS
1
.UK
PLH-3AKH
1
.UK PLH-4, 5, 6AKHS
1
.UK
OC211-A--2.qxp 04.9.28 4:41 PM Page 45
