25
When the thermal head is dirty with dust and perspiration, etc., white spots or stripes may
appear on the print. In this case, clean the thermal head in the following procedure BY
USING THE SUPPLIED CLEANING PAPER.
CAUTION
• It is recommended that after printing 10 rolls of paper the unit be cleaned using the supplied cleaning paper.
• If the symptom of the dirty head is not corrected even after cleaning, your set needs repairing, contact your dealer.
• Do not pull out the sheet and the cleaning paper while the door is closed.
This may cause extensive damage on the unit.
• Never use other cleaning papers. It may cause damage to the thermal head.
• This cleaning paper should be used only for cleaning the thermal head. Do not use it for other purpose.
Press the “POWER”
switch to turn on the
power.
Switch the left side
lever to the “OPEN”
position.
Roll the cleaning
paper and install
into the set.
12
USE OF CLEANING PAPER
2
Open the door.
3
Insert the cleaning paper.
1
Turn on the power.
OPEN
4
Close the door.
Keep pressing the
"COPY/FEED"
button until you hear
a beep.
7
Repeat the steps
3
-
6
by 2 or 3 times,
and print 1-2 sheets to verify the cleaning
effect.
5
Press the “COPY/FEED” button.
Open the door.
Take out the
cleaning paper.
Do not pull out the
cleaning paper while
the door is closed.
6
Take out the cleaning paper.
Adjust the red mark
on the cleaning
paper parallel to the
the platen roller.
Close the door
without taking out
the cleaning paper.
Cleaning paper
Red mark
Platen roller
Cleaning paper
OPEN
