Mitsubishi MXZ-2A20NA, Service Manual

Page: 53 / 102

53
10-2. Auto line correcting <MXZ-3A30NA - , MXZ-4A36NA >
Outdoor unit has an auto line correcting function which automatically
detects and corrects improper wiring or piping.
1
Improper wiring or piping can be automatically detected by pressing the piping/wiring correction switch (SW871).
When improper wiring or piping is detected, wiring lines are corrected.
This will be completed in about 10 to 15 minutes.
[How to activate this function]
1. Check that outside temperature is above 0 : .
(This function does not work when outside temperature is not above 0 : .)
2. Check that the stop valves of the liquid pipe and gas pipe are open.
3. Check that the wiring between indoor and outdoor unit is correct.
(If the wiring is not correct, this function does not work.)
4. Turn ON the power supply and wait at least 1 minute.
5. Press the piping/wiring correction switch (SW871) on the electronic control P.C. board.
Do not touch energized parts.
6. Press the switch to cancel.
NOTE : Indoor unit cannot be operated while this function is activated.
When this function is activated while indoor unit is operating, the operation will be stopped.
Operate indoor unit after the auto line correcting is finished.
Pressing the switch during detection cancels this function.
SW871
W
Be sure to check for closed valves, cracked pipes or clogged pipes.
LED indication after cancel :
LED1(Red)
Lighting
LED indication during detection:
LED indication after detection:
LED2(Yellow)
Lighting
LED3(Green)
Blinking
LED1(Red)
Lighting
LED2(Yellow)
Lighting
LED3(Green)
Goes out
LED1(Red)
Lighting
Blinking
LED2(Yellow)
Goes out
Blinking
Other indications
LED3(Green)
Lighting
Blinking Completed (Detected successfully)
Cannot be corrected
Refer to "SAFETY PRECAUTIONS WHEN LED FLASHES"
located behind the service panel.
Indication
SW871
Press the switch for more than 5 seconds.
LED will show the record of auto correcting for about 30 seconds as shown in the table below:
NOTE : Activate this function to confirm the correct wiring after replacing the electronic control P.C. board.
(Previous records are deleted when the electronic control P.C. board is replaced.)
The record cannot be shown if auto line correcting is not canceled (Refer to "How to activate this function").
LED1(Red)
Once
3 times
LED2(Yellow)
Once
3 times
LED3(Green)
Lighting
Lighting Not corrected
Corrected
Number of blinks
Wiring line
The record of auto line correcting can be confirmed in the following way:
OB444C--2.qxp 07.10.18 2:32 PM Page 53