Mitsubishi LANCER EVOLUTION-IV 1998, Workshop Manual, Page: 198 / 526

ENGINE –
Camshaft and Camshaft Oil Seal
11-12
"
B
A
CAM CAP / REAR CAP / FRONT CAM CAP
INSTALLATION
(1) Locate the camshaft dowel pins as illustrated.
(2) Temporarily tighten cam cap in two to three steps, then
torque it to specification.
Tightening torque: 20 Nm {2.0 kgf
@
m}
"
C
A
CAMSHAFT OIL SEAL INSTALLATION
(1) Apply engine oil to the entire periphery of the oil seal
lip.
(2) Pressfit the oil seal as shown.
"
D
A
CAMSHAFT SPROCKET INSTALLATION
As you did during removal, secure the camshaft sprocket
with the special tool and tighten bolt to specification.
Tightening torque: 88 Nm {9.0 kgf
@
m}
"
E
A
CAM POSITION SENSING CYLINDER
Install the cam position sensing cylinder so that the ID paint
on the cam position sensing cylinder is 90
_
with respect to
the camshaft dowel pin as shown.
Intake side
Approx. 12
_
Dowel pin
Exhaust side
MD998713
ID paint
Dowel pin
90
_