−
11
−
In such cases
Inspections
Procedures
Trouble shooting
Implement the inspections and procedures below in the following cases.
Turn the ground fault circuit interrupter on.
Turn the power switch "ON".
Place your hands all the way inside the hand drying area.
Remove any foreign substances or dirt after
turning the power switch "OFF" and the power
light goes out. Wait for at least 1 minute after
turning the power switch "OFF", and then turn it
back "ON" again.
If the hand dryer is used continually for more than
40 seconds, the power light fl ashes and the dryer
automatically stops. Remove your hands and then
re-insert them.
If the hand dryer is used continually for more than
40 seconds, the power light fl ashes and the dryer
automatically stops. Remove your hands and then
re-insert them.
Open the front cover and turn the heater switch "ON".
This unit has a built-in heater, but the air may not
feel warm when the room temperature is low.
The heater may not operate if it is used
continually.
Turn the ground fault circuit interrupter "ON" and
then turn the power switch "ON".
Turn the power switch "OFF", check that all of the
lights on the display section are off and then wait
for 1 minute before switching the power back "ON".
When the air speed switch or heater switch are
pressed, the light turn back on in the state where
the settings have been made.
Please refer to "Adjusting the air speed" (Page 6)
while adjusting the air speed.
Please refer to "Turning the heater on" (Page 6)
while turning the heater off.
The front cover is designed to come off in order to
prevent damage to the main unit if it is opened too far.
Please reattach it while referring to "Precautions for
when opening/closing the front cover" (Pages 4 and 7).
Are any lights in the display on?
Has a blackout occurred?
Was the power switch turned on while your hands
or an object was inside the hand drying area?
Has the dryer been used continually
for more than 40 seconds?
Are any lights fl ashing?
Has the dryer been used continually
for more than 40 seconds?
Are any lights fl ashing?
The heater switch is off.
Air conditioning is not working (room
temperature is 20 C or below).
Is the room temperature too high?
Was there a blackout?
Is the ground fault circuit interrupter
"OFF"?
This may fl ash if there is a malfunction
in the power supply.
It turns off 10 seconds after the air
speed switch or heater switch are
controlled to save energy.
The air speed can be adjusted.
The heater can be turned off.
Has the front cover been opened too
far?
If the above procedures do not work, turn off the power and the ground fault circuit interrupter
and have your dealer inspect and if necessary, repair the unit.
(Costs are as agreed with the dealer.)
Is the sensor blocked by dirt or dust?
Are you putting your hands in all the way?
Is the sensor in the hand drying area unclean?
No air blows even if
hands are inserted.
Air does not stop.
Stops operating
during hand drying.
The air is cold.
Air does not warm
up.
The power light does not
light up even when the
power is switched on.
The power light is
fl ashing.
The air speed light
and heater light do
not light up.
The unit makes
noise.
The air is too strong.
Turning the heater
off.
The front cover has
come off.
