Mitsubishi Fuso FK 2010, Owner'S Manual

Page: 99 / 362

6-12
Instruments and warning lamps
3. If the oil level is normal and there is no trace of
oil leaks, there is probably a problem in the lubri-
cating system. Call an authorized dealer.
CAUTION
Never continue driving with the lamp illumi-
nated. The engine could seize up.
NOTE:
The buzzer stops sounding when the vehicle is
stopped and the parking brake is activated.
7 Engine control warning lamp
•
Illumination of red lamp
The red lamp illuminates when an abnormality is
detected in the engine control system or DPF sys-
tem. The engine output may be limited or the
engine may stop depending on the location of the
fault. If the lamp illuminates, stop the vehicle at a
safe place. Place the starter switch in “ACC” or
“LOCK” position for 5 seconds or longer and then
restart the engine. If the lamp stays off, there is no
problem. If the lamp illuminates again, stop the
engine and contact the nearest authorized dealer.
The red lamp is also illuminated if you continue to
drive while the DPF indicator lamp quickly flashes.
Illumination of this lamp may indicate a blocked
DPF and/or faulty DPF system. If this lamp illumi-
nates during driving, stop the vehicle as soon as it is
safe to do so and perform the following inspection.
1. Hold the starter switch in the “ACC” or “LOCK”
position for more than 5 seconds, then restart
the engine.
2. If the warning lamp goes out, there is nothing
abnormal with the system.
3. If the warning lamp remains illuminated, have an
authorized dealer perform the necessary
inspection.
NOTE:
The warning lamp will light up when the starter
switch is turned to the “ON” position and the engine
is not running. It goes out after the engine is started
if there are no problems.
Z11795
FKFM.book Page 12 Wednesday, January 28, 2009 9:21 AM