EN-36
MULTI-SCREEN menu
MULTI-SCREEN
EDGE BLENDING
SETTING
OFF
OFF
EDGE ADJUST
COLOR MATCHING
SETTING
MEASURED DATA
MANUAL
MEASURE
1
1
2
2
opt.
ITEM
SETTING
FUNCTION
EDGE BLENDING
OFF
Select when using the projector alone.
ON
Select when using the projector to configure the multi-screen consisting
of multiple projectors.
The following settings in the SETTING become enabled to make the
overlapped area of the displayed images unnoticeable.
SETTING
EDGE ADJUST
Use to make the overlapped area of the screens unnoticeable in the
multi-screen application. Use this setting to select the edges to be
overlapped or to set the overlapped areas. (See page 49.)
BLACK LEVEL
In the multi-screen application, the black level in the areas where images
are overlapped will become bright. So, use this setting to adjust the
black level in non-overlapped areas. (See page 49.)
BRIGHT UNIFORMITY
CORRECTION
Use to correct non-uniformity in the screen brightness of the single
projector to facilitate edge blending. (See page 49.)
RESET
Use to reset the values of EDGE ADJUST , BLACK LEVEL and
BRIGHT UNIFORMITY CORRECTION to the defaults.
COLOR MATCHING
OFF
Select this option when the projector is used alone.
MANUAL
Select this option when adjusting colors while viewing the screen to
correct color variations among the projectors.
MEASURE
Select this option when adjusting colors using a measuring instrument
to correct color variations among the projectors.
MANUAL
SETTING
The test signal is displayed. Make adjustment so that the color tones of
each image match among the adjoining projectors. (See page 50.)
RESET
Use to reset the value of SETTING in the MANUAL to the default.
MEASURE
MEASURED DATA
The test signal is displayed. Measure the brightness and chromaticity of
each image using a measuring instrument (chroma meter) and enter the
measurement values. (See page 50.)
TARGET DATA
Use to set the target chromaticity value of each color. (See page 50.)
RESET
Use to reset the values of MEASURED DATA and TARGET DATA in
the MEASURE to the defaults.
• When EDGE BLENDING is ON or COLOR MATCHING is MANUAL or MEASURE, COLOR ENHANCER in the IMAGE menu is
set to MULTI-SCREEN. In this case, you cannot set any other items than MULT-SCREEN.
• The edge blending function can be used with non-directional screens. If you use a directional screen, the areas where images
are overlapped seem discontinuous depending on the viewing angle.
• The target chromaticity value entered for TARGET DATA in the MEASURE menu is just for guidance. If the obtained result
doesn’t match with the colors displayed on the adjoining projectors, adjust the value while viewing the screens.
Menu operation (continued)
