Mitsubishi MOTORS 2018 MIRAGE, Owner'S Manual

Page: 31 / 354

To unlock
Press the UNLOCK switch (2). All the doors
and the tailgate will be unlocked. If the room
lamp switch is in the middle (•) position at
this time, the room lamp will come on for ap-
proximately 15 seconds and the turn-signal
lamps will blink twice.
NOTE
l For vehicles equipped with the mirror retrac-
tor switch, the outside rear-view mirrors au-
tomatically retract or extend when all the
doors and the tailgate are locked or unlocked
using the remote control switches of the key-
less entry system. Refer to “Starting and
driving: Outside rear-view mirrors” on page
6-07.
l If the UNLOCK switch (2) is pressed and no
door or tailgate is opened within approxi-
mately 30 seconds, relocking will automati-
cally occur.
l It is possible to modify functions as follows:
For further information, please contact a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
• The time from pressing the UNLOCK
switch (2) to the moment of automatic
locking can be changed.
•
Activating the operation confirmation
function (blinking of the turn-signal
lamps) only during locking, or only dur-
ing unlocking.
NOTE
• The confirmation function (this indicates
locking or unlocking of the doors and tail-
gate with the blink of the turn-signal
lamps) can be deactivated.
• The number of times the turn-signal
lamps are flashed by the confirmation
function can be changed.
l The keyless entry system does not operate in
the following conditions:
• The key is left in the ignition switch. (ex-
cept for vehicles with keyless operation
system)
• The operation mode is not in OFF. (vehi-
cles with keyless operation system)
• A door or the tailgate is open or ajar.
l The remote control switch will operate with-
in approximately 4 m from the vehicle.
However, the operating range of the remote
control switch may change if the vehicle is
located near a power station, or radio/TV
broadcasting station.
l If either of the following problems occurs,
the battery may be exhausted.
• The remote control switch is operated at
the correct distance from the vehicle, but
the doors and tailgate are not locked/
unlocked in response.
NOTE
• The indication lamp (3) is dim or does not
come on.
For further information, please contact a
MITSUBISHI MOTORS Authorized
Service Point.
If you replace the battery yourself, refer to
“Procedure for replacing the remote con-
trol switch battery” on page 3-05.
l If your remote control switch is lost or dam-
aged, please contact a MITSUBISHI
MOTORS Authorized Service Point for a re-
placement remote control switch.
l If you wish to add a remote control switch,
please contact a MITSUBISHI MOTORS
Authorized Service Point.
The following numbers of the remote control
switches are available.
• Keyless entry key: up to 4 keys.
• Keyless operation key: up to 4 keys.
Procedure for replacing the re-
mote control switch battery
Before replacing the battery, remove static
electricity from your body by touching a met-
al grounded object.
Keyless entry system*
3-05
OA0X19E2
Locking and unlocking
3