Mitsubishi Electric TM-RFM, Instruction Manual

Page: 72 / 80

APPENDIX
App. - 5
App. 5 Compliance with the CE marking
App. 5.1 What is CE marking?
The CE marking is mandatory and must be affixed to specific products placed on the European Union. When
a product conforms to the requirements, the CE marking must be affixed to the product. The CE marking
also applies to machines and equipment incorporating servos.
A manual is available in different languages. For details, contact your local sales office.
(1) EMC directive
The EMC directive applies to the direct drive motor alone. Therefore direct drive motor is designed to
comply with the EMC directive. The EMC directive also applies to machines and equipment
incorporating direct drive motors. TM-RFM, TM-RG2M, TM-RU2M series comply with EN61800-3
Category 3. They are not intended to be used on a low-voltage public network which supplies domestic
premises; radio frequency interference is expected if it is used on such a network. The installer shall
provide a guide for installation and use, including recommended mitigation devices.
(2) Low voltage directive
The low voltage directive also applies to the direct drive motor alone. The direct drive motor is designed
to comply with the low voltage directive.
(3) Machinery directive
The direct drive motor as a single unit does not comply with the Machinery directive due to
correspondence with article1 2. (k). However, machines and equipment incorporating direct drive motors
will be complied. Please check your machines and equipment as a whole if they are complied.
App. 5.2 For compliance
Be sure to perform an appearance inspection of every unit before installation. In addition, have a final
performance inspection on the entire machine/system, and keep the inspection record.
(1) Wiring
Use wirings which complies with EN for the direct drive motor power. Complying EN products are
available as options. Refer to chapter 6 for details of the options.
(2) Performing EMC tests
When EMC tests are run on a machine and device into which the direct drive motor and direct drive
motor have been installed, it must conform to the electromagnetic compatibility (immunity/emission)
standards after it has satisfied the operating environment and electrical equipment specifications.
For EMC directive conforming methods about servo amplifiers and direct drive motors, refer to "EMC
Installation Guidelines" and each Servo Amplifier Instruction Manual.