74
3. HEAT operation (Only SEH)
<How to operate>
1
Press POWER ON / OFF button.
2
Press MODE SELECT button to set operation mode to HEAT.
3
Check
lamp is ON and set desired temperature with UP or DOWN but-
ton.
NOTES : 1. When
lamp is ON, press TIMER/TEMP button to change the
display to temperature mode.
2. Set temperature changes by 1°C in the range 18 ~ 29°C each time UP
or DOWN button is pressed.
3. The lighting lamp shows the set temperature, and the flashing lamp
shows the room temperature.
When the room temperature is equal to the set temperature, the lamp
keeps lighting, 0.5 seconds brightly and 0.5 seconds faintly.
TIMER
MITSUBISHI ELECTRIC
12
11
10
9
8
7
6
5
4
3
2
1
29
28
27
26
25
24
23
22
21
20
19
18
TIMER
TEMP
TIMER/TEMP.
UP
DOWN
POWER
COOL
ON/OFF
MODE
SELECT
FAN
SPEED
TIMER
MODE
DRY
HEAT
HIGH
LOW
AUTO
STOP
START
g
TEMP
(1) Compressor control
1
3minute time delay
To prevent overload, the compressor will not start within 3minutes after stop.
2
The compressor runs when the room temperature is higher than the set temperature.
The compressor stops when the room temperature is equal to or higher than the set temperature.
w
4degrees up control
During heat operation, lower the room temperature for 4degrees more than thermistor value.
3
The compressor stops in check mode.
4
Follow the item (5) during defrosting.
<HEAT operation time chart>
Minimum 3 minutes
w
1
ON
Thermostat
Indoor fan
Compressor
Outdoor fan
ON
LOW or HIGH
LOW
LOW
LOW or HIGH
VLo
OFF
OFF
ON
OFF
Operation starts by
P O W E R b u t t o n
ON.
Operation stops by
P O W E R b u t t o n
OFF.
Room temperature
becomes equal to
set temperature.
Room temperature
falls below set tem-
perature.
}
w
1 Even if the room temperature falls below the set temperature during this period, the compressor will not start until this period has ended.
OC281-B-3.qxp 04.2.10 2:23 PM Page 74