Mitsubishi Electric PEAD-M100, Operation Manual, Page: 7 / 124

7
3. Operation
■
About the operation method, refer to the operation manual that comes with each remote controller.
3.1. Turning ON/OFF
3.1.1. For wired remote controller
[ON] [OFF]
Press the [ON/OFF] button.
The ON/OFF lamp will light up in green,
and the operation will start.
Press the [ON/OFF] button again.
The ON/OFF lamp will come off, and
the operation will stop.
■
Operation status memory
■
Settable preset temperature range
Remote controller setting Operation mode Preset temperature range
Operation mode Operation mode before the power was turned off Cool/Dry 19 – 30 °C
Preset temperature Preset temperature before the power was turned off Heat 17 – 28 °C
Fan speed Fan speed before the power was turned off Auto 19 – 28 °C
Fan/Ventilation Not settable
3.1.2. For wireless remote controller
[ON]
■
Press the ON/OFF button ① .
Note:
●
When the unit is restarted, initial settings are as follows.
Remote Controller settings
Mode Last operation mode
Temperature setting Last set temperature
Fan speed Last set fan speed
Airflow up/down Mode
COOL or DRY Horiz. outlet
HEAT Last setting
FAN Horiz. outlet
[OFF]
■
Press the ON/OFF button ① again.
Note:
Even if you press the ON/OFF button immediately after shutting down the operation is progress, the air conditioner will not start for about three minutes.
This is to prevent the internal components from being damaged.
AAA
AAA
CLOCK
CHECK
RESET SET
TEST RUN
MODE
FAN
VANE
LOUVER
min
h
AUTO START
AUTO STOP
ON/OFF
TEMP
①
②
③
④
2 3
4
(option)
3.2. Mode select
3.2.1. For wired remote controller
F1 F2 F3 F4
Cool
Room
Set temp.
Mode Temp. Fan
Fri
Press the [F1] button to go through the
operation modes in the order of “Cool”,
“Dry”, “Fan”, “Auto”, and “Heat”. Select the
desired operation mode.
Cool Dry Fan
Auto Heat
• Operation modes that are not available to
the connected indoor unit models will not
appear on the display.
What the blinking mode icon means
The mode icon will blink when other indoor units in the same refrigerant
system (connected to the same outdoor unit) are already operated in a
different mode. In this case, the rest of the unit in the same group can
only be operated in the same mode.
3.2.2. For wireless remote controller
■
Press the operation mode ( ) button
②
and select the
operation mode 2 .
Cooling mode
Drying mode
Fan mode
Heating mode
Automatic (cooling/heating) mode
Ventillation mode
Only indicated on the following condition
Wired remote controller used
LOSSNAY connected
►