background image

EN-2

EN-3

ENGLISH

Safety precautions

Warning:

Do not use the interactive pen if it is damaged by falling from on high or stepping upon it.

The damaged part causes injury.

When you use the interactive pen, be sure to put the strap on your wrist. Do not wave the 
interactive pen with the strap put on your wrist.

If the strap is not used properly, the interactive pen may slip from your hand and hit other 
people, resulting in injury. Even when the strap is put on your wrist, if you wave the interactive 
pen, the strap may be cut and the interactive pen may hit other people, resulting in injury.

Caution:

•  Do not touch the interactive pen with wet hands. In addition, do not use the interactive pen 

with condensation on it. The intrusion of water may cause damage or other failures.

•  Use of a battery of wrong type may cause explosion.
•  Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.
•  Dispose of used batteries according to your local regulations.
•  Batteries may explode if misused. Do not recharge, disassemble, or dispose of in fi re.
•  Be sure to handle the battery according to the instructions.
•  Load the battery with its positive (+) and negative (-) sides correctly oriented as indicated on 

the remote control.

•  Keep batteries out of reach of children and pets.
•  Remove the battery, if the remote control is not used for a long time.
•  Do not combine a new battery with an old one.
•  If the solution of batteries comes in contact with your skin or clothes, rinse with water. If 

the solution comes in contact with your eyes, rinse them with water and then consult your 
doctor.

Using this interactive pen may cause damage to the screen surface depending on the screen 
used. In such a case, replace the screen with that having a solid surface.

When using the projector in Europe:
COMPLIANCE NOTICE 

This projector complies with the requirements of the EC Directive 1999/5/EC “R&TTE Directive”.

Using precautions

For Canada only:
COMPLIANCE NOTICE OF INDUSTRY CANADA

Under Industry Canada regulations, this radio transmitter may only operate using an antenna 
of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. 
To reduce potential radio interference to other users, the antenna type and its gain should 
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that 
necessary for successful communication.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is 
subject to the following two conditions: 
(1) this device may not cause interference, and 
(2) this device must accept any interference, including interference that may cause undesired 

operation of the device.

For the U.S. and Canada only:

The wireless function of this projector can be used only in the United States and Canada.
This function cannot be used legally in countries other than the above.

For Europe only:

The wireless function of this projector can be used only in Austria, Bulgaria, Czech Republic, 
Denmark, Finland, France, Germany, Greece, Hungary, Italy, Norway, Poland, Portugal, 
Romania, Slovakia, Spain, Sweden, Switzerland, Ireland, United Kingdom, Belgium, 
Netherlands, Luxembourg, Slovenia, Cyprus, Estonia, Iceland, Latvia, Lithuania, and Malta. 
This function cannot be used legally in countries other than the above. 

AT BG CZ DK

FI

FR DE GR HU

IT NO PL PT RO SK

ES SE CH IE GB BE NL LU

SI

CY EE

IS

LV

LT MT

Hereby, Mitsubishi, declares that this projector is in compliance with the essential 
requirements and other relevant provisions of Directive 1999/5/EC.

Consult our European sales companies if you wish to confi rm the Declaration of Conformity 
on this projector. (Refer to the page “Mitsubishi Projector Warranty, Sales Support and 
Service Information” for contact information.)

For Italy only:

In Italy, if used outside of own premises, general authorization is required.

For France only:

In France, the equipment must be restricted to the 2.4465-2.4835 GHz frequency range and 
must be restricted to do indoor use.

For Norway only:

In Norway, frequency band 2400-2483.5 MHz does not apply for the geographical area 
within a radius of 20 km from the centre of Ny-Alesund.

Summary of Contents for PC-380P1







Reviews: