8
Fig. 6-3
Fig. 6-4
3
6
B
1
A
4
5
2
1. Press the
button
1
to stop the air conditioner.
X G ;
is on), press the
button
3
to disable it (
is
off).
2. Press the
button
2
for 5 seconds.
K
A
&!
3. Press the
button
6
to set the displayed number
B
to "50".
K While pointing the wireless remote controller toward the receiver, press the
button
4
!;!=
4. Press the
button
6
to set the unit number of the indoor unit. (Fig. 6-3)
K While pointing the wireless remote controller toward the receiver, press the
button
4
!;!=
* When the unit number is transmitted, the selected indoor unit starts operating in the fan
mode.
You can use this step to confirm which indoor unit corresponds to the unit number you
selected to change the functions.
However, if you set the unit number to "00" or "AL", all of the indoor units in the same
refrigerant system will start operating in the fan mode.
* If you transmit a unit number that cannot be selected, the beeper sounds 3 times con-
;*!z*!z*!z!=|!
If this occurs, press the
button
5
, and then set the unit number again while the unit
!
* If the signal was not received correctly, the beeper will not sound or it will beep twice.
If this occurs, press the
button
5
, and then set the unit number again while the unit
!
5. Press the
button
6
to set the mode number. (Fig. 6-3)
K While pointing the wireless remote controller toward the receiver, press the
button
4
!;!=
V$+%GVkGk4G8V% &
cate the current setting number for the selected mode number.
8# );)!=)
};)!=}
{;)!={
X G {
beep, beep (0.4 + 0.4 + 0.4 sec.)”.
If this occurs, press the
button
5
, and then set the mode number again while the
!
* If the signal was not received correctly, the beeper will not sound or it will beep twice.
If this occurs, press the
button
5
, and then set the mode number again while the
!
6. Press the
button
6
to select the setting number. (Fig. 6-3)
K While
pointing the wireless remote controller toward the receiver, press the
button
4
!;!=
V$+%GVkGk4G8V% &
cate the setting number for the selected mode number.
8# );)!=)
};)!=}
{;)!={
* If you enter a number that cannot be set, the originally set number will be used.
* If the signal was not received correctly, the beeper will not sound or it will beep twice.
If this occurs, repeat the procedure from step 5.
7. To set another mode without changing the unit number of the indoor unit, repeat steps 5 and
6.
8. To change the unit number of the indoor unit and perform the function selection, repeat
steps 4–6.
9. Press the
button
1
to complete the function selection.
Note:
' *&&+ !/
ler for 30 seconds.
' 89& & &
+ &! "#$ "%/
$&
Function selection procedure
First, it is important to understand the procedure for the function selection. The following procedure explains how to set "LOSSNAY connectivity" in
)';& = : !
For the actual operations, refer to the following procedure.
Unit
Mode
Setting
