Mitsubishi Electric PAR-CT01MAA-PB, Installation Manual

Page: 12 / 452

– 12 –
GB
5 Install the bottom case.
Be sure to secure two places of the bottom case.
6
Cut out the cable access hole.
■
Direct wall installation (when running the cable along the wall)
• Cut out the thin-wall part on the cover (the shaded area in the right
figure) with a nipper.
• Thread the cable from the groove behind the bottom case through
this access hole.
7 Connect the connector to the top case.
Connect the connector on the bottom case to the socket on the top case.
■ Installation using a switch box ■ Direct wall installation
Remote
controller
cable
Refer to 4 .
Refer to 2 .
Single switch box
Roundhead
cross slot
screws
Seal the cable
access hole
with putty.
Refer to 4 .
Wood
screws
Remote
controller cable
To avoid deformation and damage to the
bottom case, do not overtighten the screws. To avoid damage to the bottom case, do not
make holes on it.
Important
Notice
To prevent damage to the circuit board,
remove the front cover from the top case
before cutting out a cable access hole. Note that accidentally touching the circuit
board may damage the circuit board when
cutting out a cable access hole.
Connect the connector.
To prevent malfunctions, do not remove the
protective sheet or the circuit board from the
top case. To prevent cable breakage and
malfunctions, do not hang the top controller
casing hang by the cable as shown in the
figure above.
Important
WT08580X01.book 12 ページ ２０１７年６月１９日 月曜日 午後２時１分