- 7 -
5. Remove AG-150A surface cover.
6. Wiring
Connect the cables to the AG-150A.
Refer to the AG-150A Installation Manual for details.
CAUTION
* Do not put the signal wire and power wire in the same conduit.
* When routing the cable from the top of the controller, let the cable hang down below the connector before connecting it to
the terminal block or connector as shown in the figure below to prevent water from running down the cable and cause
electric shock or fire.
Insert a flat-tip screwdriver in the holes
indicated and move the handle up to
remove the cover.
Terminal block or
connector
Good example
Bad example
Wall
DC Power cable
M-NET transmission cable
M-NET
transmission
cable
DC power cable
Back of controller
shield
Function earthing
(ground) cable
