Mitsubishi Electric MXZ-2D33VA, Service Manual, Page: 163 / 538

OPERATING PROCEDURE
PHOTOS
163
DISASSEMBLY INSTRUCTIONS 12
(1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with this connector has the
locking mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever. Hold the sleeve, and
pull out the terminal
slowly.
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
<"Terminal with locking mechanism" Detaching points>
Connector
Sleeve
Locking lever
Photo 1
1. Removing the cabinet and the panels
(1) Remove the screws fixing the service panel.
(2) Pull down the service panel and remove it.
(3) Disconnect the power supply and indoor/outdoor connecting wire.
(4) Remove the screws fixing the top panel.
(5) Remove the top panel.
(6) Remove the screws fixing the cabinet.
(7) Remove the cabinet.
(8) Remove the screws fixing the back panel.
(9) Remove the back panel.
Screws of
Service
panel
Screws of
the top panel
12-1. MXZ-2D33VA MXZ-2D40VA MXZ-2D42VA MXZ-2D42VA2
MXZ-2D53VA MXZ-2D53VA2 MXZ-2D53VAH MXZ-2D53VAH2
NOTE
: Turn OFF the power supply before disassembly.
Screws of
the cabinet
Screws of the terminal
block support and the
back panel
Photo 2
Hooks
Photo 3
Screws of
the back panel
Direction
to remove
OBH626K