En-3
● OPERATING INSTRUCTIONS ●
Operation indicator lamp
Remote control
receiving section
Emergency
operation
switch
Page 4
Horizontal vane
Air inlet
Front
panel
N
AME OF EACH PART
Indoor unit
Air outlet
Outdoor unit
Heat exchanger
Air inlet (back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
Remote controller
Emergency operation switch
Spec name plate *1
Outdoor units may be different in appearance.
*1 The manufacturing year and month is indicated on the spec name plate.
Spec name plate *1
Air cleaning fi lter
(Silver-ionized air
purifi er fi lter)
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit
when the signal is
received.
Operation
display section
OFF/ON
(stop/operate) button
Temperature
buttons
Page 4
Operation
select button
Page 4
ECONO COOL
button
Page 5
FAN speed control
button
Page 5
VANE control
button
Page 5
TIME, TIMER set buttons
Page 4, 5
Increase time
Decrease time
CLOCK button
Page 4
RESET button
Page 4
Lid
Slide the lid down to open
the remote controller. Slide
it down further to get to the
change No. buttons.
Battery replacement indicator
Page 4
Only use the remote controller provided with the unit.
Do not use other remote controllers.
If two or more indoor units are installed in proximity to one another, an indoor
unit that is not intended to be operated may respond to the remote controller.
Air fi lter
(Air purifying fi lter)
Refer to note below
Note:
How to set remote controller exclusively for a particular indoor unit
A maximum of 4 indoor units with wireless remote controllers can be used in a room.
To operate the indoor units individually with each remote controller, assign a number
to each remote controller according to the number of the indoor unit.
This setting can be set only when all the following conditions are met:
• The remote controller is powered OFF.
(1) Hold down
button on the remote controller for 2 seconds to enter the pairing
mode.
(2) Press
button again and assign a number to each remote controller.
Each press of
button advances the number in the following order: 1 → 2 →
3 → 4.
(3) Press
button to complete the pairing setting.
After you turn the breaker ON, the remote controller that fi rst sends a signal to an
indoor unit will be regarded as the remote controller for the indoor unit.
Once they are set, the indoor unit will only receive the signal from the assigned
remote controller afterwards.
JG79Y146H01_en.indd 3
2016/09/09 8:57:54
