OPERATING PROCEDURE
PHOTOS/FIGURES
6. Removing the outer vane motors
(horizontal) (Photos 8, 10, 11, 12, 13)
(1) Remove the front panel, the outer vanes (R) (L)(hori-
zontal), the panels (U) (R) (L) (F), the corner boxes
(R) (L), Wi-Fi interface, DISPLAY and i-see SENSOR
ASSEMBLY, V.A. clamp, and the electrical cover.
(2) Remove the following connector (Photo 8):
<Indoor electronic control P.C. board>
CN151 (Vane motors)
(3) Pull out the drain hose from the nozzle assembly.
(4) Pull and remove the nozzle assembly (catches on left,
right, and center) (Photo 10).
(5) Cut off the cable tie to secure the lead wires on the
right side of the nozzle assembly (Photo 12).
(6) Remove the tape to secure the lead wires and the alu-
minum tape on the front of the nozzle assembly (Photo
11).
Removing outer vane motor (R) (horizontal) (Photo 12)
(7) Loosen the lead wires, and disconnect the connector
of the outer vane motor (R) (horizontal).
(8) Remove the 2 screws of the outer vane motor (R)
(horizontal).
(9) Remove the outer vane motor (R) (horizontal).
Removing outer vane motor (L) (horizontal) (Photo 13)
(10) Loosen the lead wires, and disconnect the connector
of the outer vane motor (L) (horizontal).
(11) Remove the 2 screws of the outer vane motor (L)
(horizontal).
(12) Remove the outer vane motor (L) (horizontal).
45
Photo 11 (Front view of nozzle assembly)
Tape to secure the lead wires
Aluminum tape
Photo 12 Outer vane motor (R) (horizontal)
Cable tie
Screws
Outer vane motor (R) (horizontal)
Photo 13 Outer vane motor (L) (horizontal)
Screws
Outer vane motor (L) (horizontal)
Photo 10
Catches of nozzle assembly (3 places)
Photo 13
Photo 12
OBH766B
Summary of Contents for MSZ-LN18VGB - E1
Page 50: ......
