background image

En-7

● OPERATING INSTRUCTIONS ●

Even if these items are checked, when the unit does not recover from the 

trouble, stop using the air conditioner and consult your dealer.

Symptom

Explanation & Check points

Indoor Unit

The unit cannot be operated.

•  Is the breaker turned on?

•  Is the power supply plug connected?

•  Is the ON timer set? 

 Page 5 

All LED lamps on the indoor 

unit are blinking.

•  Is  the  horizontal  vane  installed  correctly? 

 Page 6 

The horizontal vane does not 

move.

•  Are the horizontal vane and the vertical vane 

installed correctly? 

 Page 6 

•  Is the fan guard deformed?

The unit cannot be operated 

for about 3 minutes when 

restarted.

•  This protects the unit according to instruc-

tions  from  the  microprocessor.  Please 

wait.

Mist is discharged from the air 

outlet of the indoor unit.

•  The cool air from the unit rapidly cools mois-

ture in the air inside the room, and it turns 

into mist.

The swing operation of the 

HORIZONTAL VANE is 

suspended for a while, then 

restarted.

•  This is for the swing operation of the HORI-

ZONTAL VANE to be performed normally.

The air fl ow direction changes 

during operation.

The direction of the horizontal 

vane cannot be adjusted with 

the remote controller.

•  When the unit is operated in COOL or DRY 

mode,  if  the  operation  continues  with  air 

blowing down for 0.5 to 1 hour, the direction 

of the air fl ow is automatically set to position 

(1) to prevent water from condensing and 

dripping.

The unit starts operation by 

itself when the main power 

is turned on, though it isn’t 

operated with the remote 

controller.

•  These models are equipped with an auto re-

start function. When the main power is turned 

off without stopping the unit with the remote 

controller and is turned on again, the unit 

starts operation automatically in the same 

mode as the one set with the remote control-

ler just before the shutoff of the main power. 

Refer to “Auto restart function” 

 page 4 

.

Outdoor Unit

The fan of the outdoor unit 

does not rotate even though 

the compressor is running. 

Even if the fan starts to rotate,  

it stops soon.

•  When the outside temperature is low dur-

ing  cooling  operation,  the  fan  operates 

intermittenly  to  maintain  suffi cient  cooling 

capacity.

Water leaks from the outdoor 

unit.

•  During COOL and DRY operations, pipe or 

pipe connecting sections are cooled and this 

causes water to condense.

Symptom

Explanation & Check points

Remote controller

The display on the remote 

controller does not appear 

or it is dim. The indoor unit 

does not respond to the 

remote control signal.

•  Are the batteries exhausted? 

 Page 3 

•  Is the polarity (+, -) of the batteries correct?

 Page 3 

•  Are any buttons on the remote controller of 

other electric appliances being pressed?

Does not cool

The room cannot be cooled  

suffi ciently.

•  Is  the  temperature  setting  appropriate? 

 Page 4 

•  Is  the  fan  setting  appropriate?  Please 

change fan speed to higher setting.

•  Is the fi lter clean? 

 Page 6 

•  Is the fan or heat exchanger of the indoor unit 

clean? 

 Page 6 

•  Are there any obstacles blocking the air inlet 

or outlet of the indoor or outdoor unit?

•  Is a window or door open?

The room cannot be cooled 

suffi ciently.

•  When  a  ventilation  fan  or  a  gas  cooker  is 

used in a room, the cooling load increases, 

resulting in an insuffi cient cooling effect.

•  When  the  outside  temperature  is  high,  the 

cooling effect may not be suffi cient.

Airfl ow

The air from the indoor unit 

smells strange.

•  Is the fi lter clean? 

 Page 6 

•  Is the fan or heat exchanger of the indoor unit 

clean? 

 Page 6 

•  The unit may suck in an odor adhering to the 

wall, carpet, furniture, cloth, etc. and blow it 

out with the air.

Sound

Cracking sound is heard.

•  This sound is generated by the expansion/

contraction  of  the  front  panel,  etc.  due  to 

change in temperature.

“Burbling” sound is heard.

•  This sound is heard when the outside air is 

absorbed from the drain hose by turning on 

the range hood or the ventilation fan, making 

water fl owing in the drain hose to spout out.

  This sound is also heard when the outside air 

blows into the drain hose in case the outside 

wind is strong.

Mechanical sound is heard 

from the indoor unit.

•  This is the switching sound in turning on/off 

the fan or the compressor.

The sound of water fl owing 

is heard.

•  This is the sound of refrigerant or condensed 

water fl owing in the unit.

Hissing sound is sometimes 

heard.

•  This is the sound when the fl ow of refrigerant 

inside the unit is switched.

In the following cases, stop using the air conditioner and consult your 

dealer.

•  When water leaks or drips from the indoor unit.

•  When the upper operation indicator lamp blinks.

•  When the breaker trips frequently.

•  The remote control signal is not received in a room where an electronic ON/OFF 

type fl uorescent lamp (inverter-type fl uorescent lamp, etc.) is used.

•  Operation of the air conditioner interferes with radio or TV reception. An ampli-

fi er may be required for the affected device.

•  When an abnormal sound is heard.

W

HEN YOU THINK THAT TROUBLE HAS OCCURRED

SG79F322H03_en.indd   7

2009/06/26   10:54:49

Summary of Contents for MSY-GC25VA













Reviews: