- 11 -
(2) As shown in Fig. 2 on the next page, mark the label holder to indicate the size
obtained by subtracting the holder amount S from the stitching pattern
position of the label to be sewn on. (At this time, the holder amount S is set to
the size of the needle or more. If set too large, the stitches may miss the
material.)
(3) Cut the plate along the marked lines using a cutter knife, fret saw or file, etc.
6.3 Drilling the work holder plate
A hole to allow the needle to escape at the home position, and holes to store
and position the label must be drilled on the work holder. Drill the plate with the
following procedures.
(1) Install the parts removed when preparing the label holder plate at their
original positions.
(2) Install the Fig. No. 149 work holder plate to the bottom of the Fig. No. 148
clamp frame using the Fig. No. 150 pan-head screw.
(3) Depress the [Black] side of the 2-pedal foot switch, and lower the work holder.
(4) After placing a label under the label holder plate, depress the 1-pedal foot
switch, and lower the label holder. Check that the label is pressed at the
correct position.
(5) Make marks at the moved home position and at the four corners of the label.
(6) Raise the label holder and work holder, and remove the work holder plate.
(7) As shown in Fig. 2, mark an escape hole for a
φ
10 or more needle at the
home position, and mark lines connecting the four corners of label.
(8) Cut out the plate along the marked lines using a cutter knife, fret saw or file, etc.
Fig. 2
