background image

 
 

 
 
 
 
 
 

 
 

 

This product is designed and intended for use in the residential,   

commercial and light -industrial environment. 

 
This product at hand is   
based on the following 
EU regulations: 

・ 

Low Voltage Directive 73/23/EEC 

・ 

Electromagnetic Compatibility Directive 
2004/108/EC 

 

 
 

 
NOTE: 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to 
radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. 
If this equipment does cause harmful interference to radio or television reception, which can be determined 
by turning the equipment off and on, the use is encouraged to try to correct the interference by one or more 
of the following measures: 
 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and receiver. 

Connect the equipment into an outlet on an circuit different from that to which the receiver is 
connected. 

Consult the dealer or an experienced radio/TV technician for help. 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN

 

WT04918X01

8

7

Summary of Contents for MN Converter

Page 1: ... max You cannot use USB cable To set Remote error notification function various settings e g reception settings must be made on a personal computer with the modem or built in modem Register the phone number and the building name to be contacted when an error occurs and the error type to be notified Refer to the Operating manual of the MAINTENANCE TOOL Notes When Remote error notification function ...

Page 2: ...wer LED LED7 is not lighting no power is being supplied Check the wiring Check whether the power LED LED7 is lit Check whether the voltage of the M NET transmission contact is between DC17 30V MN Converter does not run Check whether the operation status LED LED5 is lit When the operation state LED LED5 does not light this device does not work properly Check whether SW1 1 to 5 are turned OFF Check ...

Page 3: ...hen the setting is completed the modem sends back OK command This is the end of the modem setting by AT command 7 Close the MAINTENANCE TOOL After initializing the modem connect each unit as shown in the System configuration figure connected with the modem Example on page 5 3 Communication error with the modem When the MN Converter cannot communicate with the modem properly disable data compressio...

Page 4: ...lled and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the use is encouraged to try to correct the interference by ...

Reviews: