Mitsubishi Electric MEHITS CH, Technical Manual

Page: 11 / 34

[3. Specification ]
7
[5] Models compatible with apportioned electricity billing function
The table below shows the support status of the AE-200 apportioned electricity billing function for each model of units.
○
: Supported *1
△
: Not supported
(Direct meter readings are used for apportionment.)
×
: Not supported
Apportioned electricity billing function
Remarks
Systems where electric
energy is metered (with-
metering-device method)
Systems where electric
energy is entered
manually (no-metering-
device method)
City Multi
*2
Y series ○ ○
HP series ○ ○
R2 series ○ ○
WY series
○ ○
WR2 series
○ ○
S series ○ ○
HVRF series ○ ○
Electric energy consumption
of the outdoor units will be
apportioned by the thermo-ON
time, even if apportionment by
capacity save amount is selected.
Large capacity floor standing
PAC
○ ○
Separately install an electricity
meter for packaged air conditioner
for equipment.
LOSSNAY ○ ○
OA Processing Unit ○ ○
Power for humidifying is not taken
into account.
P-series (Mr. Slim) *3*4
○ ○
Separately install an electricity
meter for Mr. Slim air conditioner.
AK-control unit (Mr. Slim)
*3
○ ○
Apportioned in the same manner
as to City Multi.
M-series (RAC) △ ×
Air To Water (PWFY) ○ ○
HWHP
(CAHV/CRHV/QAHV)
× ×
Chiller unit × ×
MEHITS CH & HP × ×
General equipment via DIDO
controller
△ ×
General equipment via indoor
unit free contact
△ ×
Cannot be monitored or operated
with the AE-200/AE-50/EW-50.
K-control unit × ×
Cannot be monitored or operated
with the AE-200/AE-50/EW-50.
*1: Some types of this model of units do not support the apportioned electricity billing function.
*2: REPLACE Multi is included.
*3: Only when the following M-NET adapter is used, apportionment is possible by setting the apportioning mode for the outdoor unit electric
energy to [Capacity save amount].
PAC-SJ10MA, PAC-SJ18MA, PAC-SJ31MA
When other model of M-NET adapter is used in the system, set the apportioning mode to [Thermo-ON time] or [Fan operation time].
*4: Select one of the “Power source of A-control unit” setting options from [Same power source (O/U - I/U)] and [Separated power source
(O/U- I/U)].