—30—
(7) Light receiving circuit board
1
Remove the blower. See (5)
1
~
7
.
2
Remove the panel (front). See (6)
2
~
5
.
3
Remove clamping screws for the duct and the side plate.
(four PTT screws 4 x 16, indicated by
O
)
Cautions for assembly
• Replace the packing used at the disassembled section with
new one.
• Take care not to twist the packing when replacing it.
• Be careful not to omit to install any O ring or packing.
Cautions for assembly
Closely contact the panel (lower) and the panel (rear) before
clamping with screws. (indicated by
O
)
Cautions for assembly
Confirm that there are no cracks on the panel (center).
(indicated by
O
)
4
Remove clamping screws from the back.
(eight special screws 4 x 16, indicated by
O
)
5
Remove the panel (lower).
Cautions for assembly
• Replace the packing used at the disassembled section with
new one.
• Take care not to twist the packing when replacing it.
6
Remove the panel (rear).
Summary of Contents for JT-SB116EH-W-CA
