Mitsubishi Electric GT14, User Manual

Page: 68 / 1546

5 - 4
5. UL, cUL STANDARDS AND EMC DIRECTIVE
5.2 EMC Directive
5.2.2 EMC Directive-Compliant System Configuration
The information of the EMC Directive compliant models, contact your local distributor.

GOT
Use any of the following GOTs with which CE mark logo is printed on the rating plate.
When using a GOT other than shown below, the system does not conform to the EMC Directive.
POINT POINT POINT
Checking method of hard ware version.
Confirm the hardware version with the products rating plate.

Connection method
Use the following methods to connect with the GOT to ensure compliance with the EMC Directive.
: Compliant with EMC Directive : Not compliant with EMC Directive
*1 When connecting the GOT to other controllers as a PLC manufactured by other company, create the cable (by the user) and
configure the system to meet the EMC Directive specifications for the connected device.
POINT POINT POINT
(1) System configuration
GT14 Handy conforms to the EMC Directive only when used in the connection type above, via connector
conversion box.
(2) Connected devices
If connecting to the PLC or microcomputer other than Mitsubishi products
(MELSEC-Q series, MELSEC-L series, MELSEC-QnA , MELSEC-A series or MELSEC-FX series) please
refer to the EMC Directive compliance manual for that specific device.
Item Model Version
GT14 HandyGOT
GT1455HS-QTBDE
GT1450HS-QMBDE
Hardware version B or later
Connector Conversion Box
GT16H-CNB-42S Hardware version D or later
GT16H-CNB-37S -
GT11H-CNB-37S -
Connection method
*1
GT14 Handy
Direct connection to CPU
Computer link connection
CC-Link connection (via G4)
CC-Link connection (via GT11H(S)-CCL)
Ethernet connection
GOT multi-drop connection
Other connections
*1
AA
Hardware Version
MITSUBISHI ELECTRIC CORPORATION