Mitsubishi Electric EMU4-CNT-MB, User Manual

Page: 36 / 136

35
6. Procedure for Setup/Operation
The following shows the overall flow on setup or operation.
*To use this unit, it is required to set it up with Control Unit Engineering Tool (EMU4-KNET).
The Tool can be downloaded for free from the Mitsubishi FA Global site.
The site URL is described on the back cover.
*The following procedure is for one system. When there are multiple systems, conduct the setup/operation for each system.
6.1 First Setup
Operation of Control unit Operation of Control Unit Engineering Tool
Create the project.
Refer to
5.5.1 Creating the Project .
Create the system.
Refer to
7.1 System Management .
Write the network information into the
control unit.
Refer to
7.10.1 Writing Network
Information .
Connect the parent terminal of control
unit and the computer with a LAN cable.
Start
Yes
No
Change the STOP/RUN switch of the
parent terminal from RUN to STOP.
To the next page
Set up the network information for each
control unit in the system.
Refer to
7.5 Setting of Terminals .
Have you set up the network information
for every control unit in the system?
Make a one-to-one connection between
the control unit and the computer with a
LAN cable.
Yes
No
Have you set up the password for
every control unit in the system?
Set up the password of the control unit.
Refer to
10.3 Change of Password.
Connect the lithium battery to the control unit.
For details, refer to
4.3.6
Connecting/Replacing the Lithium
Battery
.
Turn on the auxiliary power of the control unit.
Connect the lithium battery
in a non-energized state.
Make a one-to-one connection between
the control unit and the computer with a
LAN cable.