101
7.10
Write of Network Information
This function is used when the network information (Ethernet or MODBUS RTU communication) of the control unit is
confirmed or changed. Make a one-to-one connection between the target terminal unit and the computer via Ethernet.
After the connection, the write/read of network information is executed.
For details on the network information, refer to
*This function is available when the target terminal is in the STOP status of control operation.
If you attempt to execute it in the RUN status, a message will appear to ask whether to execute after the status is changed
to STOP.
Writing Network Information
(1) Select a terminal of the write target from the left table.
The selected terminal is displayed in blue.
In the
Value to write
columns of the table, the network information registered at the terminal setting is displayed.
(2) Make a one-to-one connection between the computer and the write target terminal with a LAN cable.
*Set the computer’s IP address in order to be in the same network.
(3) Enter the IP address and password of the target terminal.
The default IP address is 192.168.3.11.
For the password, refer to
(4) Click the
Writing
button.
(5) After the write has been completed, the following message appears.
Click the
OK
button to close the message.
If the write execution fails, refer to
to identify the source. After eliminating it, execute the write again.
<When changed to the IP address of the same network>
<When changed to the IP address of a different network>
Network information registered
at the terminal setting
The default setting appears when the
window is opened.
If it is different, change to the current
IP address.
