118
(3) The check result is displayed in the table on the bottom of the window.
When an IP addresses available for communication has been found, the following message appears for confirmation.
To stop the check, click the
Cancel
button.
When there is no IP address, the following message appears.
When executing the search in a
different network, change the computer’s IP address and search range of IP addresses.
10.6 Check of F/W Version
You will check the firmware version of every control unit in the system.
(1) Connect the parent terminal and the computer with a LAN cable.
In addition, connect each control unit in the system together via MODBUS RTU communication.
*Set the computer’s IP address in order to be in the same network.
(2) Click the
F/W version confirmation
button.
<When an IP address available for communication has been found>
<When there is no IP address available for communication >
