EN-36
Connection
For details of the connection, see “LAN control UTILITY operation manual” in the CD-ROM.
When STANDBY MODE in the INSTALLATION menu or the EFFICIENT MODE menu of the projector
is set to LOW, the LAN network is disabled. To enable the LAN network, set STANDBY MODE to
STANDARD. (See page 23.)
Configure the initial network settings first.
You can configure the initial settings using the projector menu (see pages 30 to 32) or ProjectorView or
ProjectorView. For details of ProjectorView and ProjectorView, see “LAN control UTILITY operation manual” in
the CD-ROM.
Using the User Manual
The User Manual for LAN Control Utility is prepared in the Portable Document Format (PDF) in the CD-ROM.
Opening the User Manual:
1. Load the CD-ROM into the CD-ROM drive.
2. Open CD-ROM “PROJECTOR.”
3. Double-click on “MANUAL_LAN.HTML” within the CD-ROM. A language selection list for the User Manual will be
displayed.
4. Move the mouse pointer to the desired language and click.
PJLink™ supported commands
The table below shows commands to control the projector using the PJLink™ protocol.
Command
Description
Remark (Parameter)
POWR
Power control
0 = Standby
1 = Power on
POWR ?
Inquiry about the power state
0 = Standby
1 = Power on
2 = Cooling down
3 = Warming up
INPT
Input switching
11 = COMPUTER1
12 = COMPUTER2
21 = VIDEO
22 = S-VIDEO
31 = HDMI
INPT ?
Inquiry about input switching
AVMT
Mute control
30 = Video and audio mute disable
31 = Video and audio mute enable
AVMT ?
Inquiry about the mute state
ERST ?
Inquiry about the error state
1st byte: Fan error, 0 or 2
2nd byte: Lamp error, 0 to 2
3rd byte: Temperature error, 0 or 2
4th byte: Cover open error, 0 or 2
5th byte: Always 0
6th byte: Other error, 0 or 2
0 to 2 mean as follows:
0 = No error detected, 1 = Warning, 2 = Error
LAMP ?
Inquiry about the lamp state
1st value (1 to 5 digits): Cumulative LAMP operating time (This item shows
a lamp operating time (hour) calculated based on
that LAMP MODE is LOW.)
2nd value: 0 = Lamp off, 1 = Lamp on
INST ?
Inquiry about the available inputs
The following value is returned.
“11 12 21 22 31”
NAME ?
Inquiry about the projector name
The projector name set on the NETWORK menu or the ProjectorView
Setup window is returned.
INF1 ?
Inquiry about the manufacturer name
“MITSUBISHI” is returned.
INF2 ?
Inquiry about the model name
“FD730U” is returned.
INF0 ?
Inquiry about other information
No other information is available. No parameter is returned.
CLSS ?
Inquiry about the class information
“1” is returned.
•
This projector is fully compliant to the specifications of JBMIA PJLink™ Class 1. It supports all the commands defined by
PJLink™ Class 1, and the compliance has been verified with the PJLink™ standard specifications Version 1.0.
Advanced features (continued)
