9
en
5. Electrical work
5.1. Indoor unit (Fig. 5-1, Fig. 5-2, Fig. 5-3)
1. Loosen the two screws securing the electric component cover, and then slide and
remove the cover.
2. Route each cable through the wiring intake into the electric component box. (Procure
power supply cable and control cable locally.)
3. Securely connect the power supply cable and control cable to the terminal blocks.
4. Secure the wires with the cable straps inside the electric component box. Secure
the wires with cable straps as cushioning components so that no stress is applied
to the connecting sections of the terminal block when tension is generated.
5. Attach the electric component cover as it was.
• Do not allow slackening of the terminal screws.
• Always install earth.
(Earth cable dia: Thicker than 1.6 mm)
• Fix power supply cable and control cable to electric component box by using buffer
bushing for tensile force. (PG connection or the like.)
A
Electric component cover
B
Electric component box
C
Entry for power supply cable
D
Entry for remote control cable and trans-
mission cable
E
Cable clamp
F
Power supply terminals (L, N)
G
Transmission terminals (M1, M2, S)
H
MA Remote controller terminal (1. 2)
I
Indoor controller
J
Remote control cable
K
Transmission cable
L
Power supply cable
M
Cable strap
N
L
F
L
Fig. 5-1
55 mm
12 mm
JKL
H
E
F
G
K
M
C
J
M
Secure with a band
3
(small) at the location
shown in the diagram
Fig. 5-2
CN5Y
CN4Z
CN90
Caution:
• Before installing the grille, make sure that the junction cable is connected.
• If the grille has signal receiver or i-see Sensor, the pack of grille includes
junction cables.
■
When using the panel with wireless signal receiver or i-see Sensor, install
wireless junction cable for connecting with the cable from the panel through
the following steps before installing the main unit.
Signal receiver:
CN90
i-see Sensor:
CN5Y
i-see Sensor motor: CN4Z
Warning:
• Insert hook the electric component cover into the bent support on the electric
component box and attach the cover securely. If it is attached incorrectly, it
could result in a fire, electric shock due to dust, water, etc.
• Use the specified indoor/outdoor unit connecting cable to connect the indoor
and outdoor units and fix the cable to the terminal block securely so that no
stress is applied to the connecting section of the terminal block. Incomplete
connection or fixing of the cable could result in a fire.
15
Fig. 5-3
Be sure to connect the remote
controller cable (0.3 mm) to the
locations shown in the diagram.
Secure the remote control cable/
indoor-outdoor connection cable
with the cable strap.
Cable strap
12
(mm)
D
C
I
A
B
Caution:
Wiring for remote controller cable shall be apart (5 cm or more) from power
source wiring so that it is not influenced by electric noise from power source
wiring.
BH79A523H02_01en.indd 9
2020/09/25 16:13:21
011
