Mitsubishi Electric City Multi PLFY-P VCM-E, Operation Manual

Page: 5 / 58

5
ON OFF
ON OFF
TIMER SET
ON/OFF
CLOCK
˚C
˚C
FILTER
CHECK TEST
TEMP.
A
2 1
B
2. Operation
↑
TIMER SET
ON/OFF
CLOCK
ON OFF
˚C
˚C
FILTER
CHECK TEST
TEMP.
1
D
B
2 3
C A
2.7. Using the timer
1) Set the current time
1 Press button to display the “CLOCK”
B
.
Remote CLOCK
→
CLOCK
ON
→
CLOCK
OFF
→
No Display
controller display
A
2
Each time you press button, the time increases in increments
of one minute. Each time you press button, the time decreases
in increments of one minute.
• Press and hold the button to rapidly change the time.
• The time changes in increments of one minute
→
ten minutes
→
in units
of hour; in this order.
• Approximately ten seconds after pressing the button, the display on the
remote controller will turn off.
The example shows a timer set for operation start at 8:00 and end at 17:00.
2) Set the mode to continuous as follows
1 Press button to display
D
.
3) Set the time to start the unit as follows
2 Press button to display
B ON
.
3 Press
TIMER SET
button to set the time that you want the unit to start.
The start time is displayed at
A
.
4) Set the time to stop the unit as follows
2
Press button to display
C OFF
.
3 Press
TIMER SET
button to set the time that you want the unit to stop.
The stop time is displayed at
A
.
5) Set the mode to timer as follows
1 Press button to display
D
.
B
A
D
C
Caution:
• Always turn off the power, first on the remote controller and then
the main switch, before cleaning or servicing the unit.
• When installing or removing the filter or the intake grille, do not
stand on an unsteady surface. You may fall and injure yourself. Be
also careful not to let dust fall into your eyes.
Dirty or clogged filters block the airflow and reduce efficiency. Very dirty
filters can damage the air-conditioner itself.
Intake grille removal
1 Pull the catch on the intake grille in the direction indicated by the arrow
and it should open.
2
Unhook the hinges to remove the intake grille from the grille.
Filter removal
1
Open the intake grille.
2 Release the catch on the center edge of the intake grille and pull the
filter forward to remove the filter.
A
Catch
B
Grille
C
Intake grille
D
Filter
3.1. Cleaning the filters and the indoor unit
Cleaning the filter
• Clean the filter using a vacuum cleaner. If you do not have a vacuum
cleaner, tap the filter against a solid object to knock off dirt and dust.
• If the filter is especially dirty, wash it in lukewarm water. Take care to
rinse off any detergent thoroughly and allow the filter to dry completely
before putting it back into the unit.
Caution:
• Do not dry the filter in direct sunlight or by using a heat source,
such as an electric heater: this may warp it.
• Do not wash the filter in hot water (above 50°C), as this may warp
them.
• Make sure that the air filter is always installed. Operating the unit
without air filter can cause malfunction.
3. Care and cleaning