Mitsubishi Electric CC-Link IE Field NZ2GF12A-60IOLH8, User Manual

Page: 142 / 162

140
APPX
Appendix 2 Remote Registers
Details of Remote Registers
Module status area (RWr0)
■
Initial processing request flag (RWr0.b8)
The operations of Initial processing request flag (RWr0.b8) and Initial processing completion flag (RWw0.b8) vary depending
on the setting value of Initial operation setting.
For details on the initial operation setting, refer to the following.

Page 84 Initial operation setting
• When With initial processing is set
After the module is powered on, Initial processing request flag (RWr0.b8) turns on. Create a program where initial processing
is executed by using Initial processing request flag (RWr0.b8) and Initial processing completion flag (RWw0.b8). When Initial
processing completion flag (RWw0.b8) is turned on, Remote READY (RWr0.b11) turns on. Also when Initial processing
completion flag (RWw0.b8) is turned on, Initial processing request flag (RWr0.b8) turns off.
When setting parameters using Initial processing request flag (RWr0.b8) as an interlock as shown in the
program example, set "Initial operation setting" to "With initial processing". After that, perform initial
processing and check that Remote READY (RWr0.b11) is on.
For program examples of initial processing, refer to the following.

Page 105 Program example
*1 When data link starts at the same time of when the module is powered on
*2 When an external input device connected to X0 is on
(1) The setting value is changed by a program.
(2) The operation starts with the setting value A.
ON
ON
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
(2)
(1)
500ms
Initial processing request flag (RWr0.b8)
(Setting value A) Default
Module power supply
*1
Channel 1 (CQ) external input signal 0
(RX0)
*2
Controlled by the IO-Link module
Controlled by the program
Initial processing completion flag (RWw0.b8)
Remote READY (RWr0.b11)
Module setting