Mitsubishi Electric CC-Link IE Field NZ2GF12A-60IOLH8, User Manual

Page: 107 / 162

9 PROGRAMMING
9.2 Program Example of Setting Parameters Using a Dedicated Instruction
105
9
8.
Display the refresh parameter setting window and configure the setting as follows.
[Navigation window]  [Parameter]  [Module Information]  [RJ71GF11-T2]  [Module Parameter]  [Basic Settings]
 [Refresh Settings]
9.
Write the set parameter to the CPU module of the master station and reset the CPU module, or turn off and on the power
supply.
[Online]

[Write to PLC]
In this example, default settings are used for parameters other than the above. For details on parameters,
refer to the following.

Page 45 Parameter Setting

User's manual for the master/local module used
Checking the network status
When the parameters are set, check that the data link status is normal.
The following table lists the IO-Link module LED indications for normal communications.
Program example
LED Status
RUN LED On
ERR. LED Off
UA LED Green
US LED Green
LINK LED(P1) On
L ER LED(P1) Green
Classification Label name Description Device
Module label GF11_1.bSts_DataLinkError Own station data link error status SB0049
GF11_1.bnSts_DataLinkError_Station[1] Data link status (each station) (station
No.1) SW00B0.0