Mitsubishi Electric BEPP K10, Service And Maintenance Manual, Page: 38 / 65

Hardware
38 Mitsubishi Electric, MA00758A
3.7.7 Replacing the Complete Front
The following is needed:
– A new front, see the Available Spare Parts list.
– A torx T10 screwdriver.
E1012, E1022, E1032, E1041, E1043, E1060, E1061, E1062 and
E1063
Follow the steps below to replace the complete front of the operator panel:
1. Power off the operator panel.
2. Follow the steps 1-6 in the Replacing the Display/Display Cable instructions for
the current panel model.
3. Attach the new front.
4. Re-assemble the unit.
E1070 and E1071
Follow the steps below to replace the complete front of E1070/E1071:
1. Power off the operator panel.
2. Follow the steps 1-3 and step 5 in the Replacing the Display/Display Cable
instruction for E1070/E1071, but in step 3, do not remove the display cable.
3. Attach the new front.
4. Re-assemble the unit.
E1100
Follow the steps below to replace the complete front of E1100:
1. Power off the operator panel.
2. Follow the steps 1-3 and step 5 in the Replacing the Display/Display Cable
instruction for E1100, but in step 3, only disconnect the flex cable (do not
remove the power card).
3. Attach the new front.
4. Re-assemble the unit.
E1101
Follow the steps below to replace the complete front of E1101:
1. Power off the operator panel.
2. Follow the steps 1-3 and 5 in the Replacing the Display/Display Cable instruction
for E1101, but in step 3, only disconnect the flex cables and the LED cable (do
not remove the power card).
3. Attach the new front.
4. Re-assemble the unit.
Note:
Make sure you have adequate ESD protection
.