Mitsubishi Electric A3112, User Manual

Page: 44 / 68

English-43
English
U-12 Remote control (continued)
Carry out as necessary
5) Read command
The computer sends the command without datacode to the monitor.
After receiving this command, the monitor returns the command with datacode including the current status to the computer.
Example: When the computer asks the power status of the monitor, and the status of the monitor is powered-on.
Control command from computer
Return command from monitor to
computer
Description of command
30 30 76 50 0D ‘0’‘0’‘v’‘P’[enter]
Sending a command for checking the
power status
30 30 76 50 31 0D ‘0’‘0’‘v’‘P’‘1’[enter] Monitor is powered-on.
Structure of the Read-command
ASCII HEX
Function Data (Receive) Function Data (Receive)
POWER
ON vP 1 76 50 31
OFF (Sleep) vP 0 76 50 30
Input
HDMI1 vI r1 76 49 72 31
HDMI2 vI r7 76 49 72 37
DVI-D vI r2 76 49 72 32
D-SUB vI r3 76 49 72 33
OPTION* vI r5 76 49 72 35
DISPLAYPORT vI r6 76 49 72 36
VIDEO vI v1 76 49 76 31
YPbPr vI v2 76 49 76 32
S-VIDEO vI v3 76 49 76 33
Internal
temperature
Around the main
board
Resolution
1˚C
tc1 (ex.) +25 74 63 31 2B 20 32 35
Around the power
supply
Resolution
1˚C
tc2 (ex.) +31 74 63 32 2B 20 33 31
* OPTION can be used when an expansion module is mounted on the option slot.
NOTE:
The monitor will acknowledge the power-on/off command issued from the OPS-compliant computer, however, it will not execute
the command. This is not a malfunction. For automatic operation, use SCHEDULE in the CONFIGURATION2 menu of the OSD
screen function.
LAN Remote control
When you connect the monitor and the computer using a LAN hub and a LAN cable (see page 27) and then confi gure the network
settings using LAN SETTING in the CONFIGURATION2 menu of the OSD screen function, you can remote-control the monitor using
the same commands as those for RS-232C.
1. Setting procedure
(1) Select LAN as the communication interface used for the serial communication function. (See page 53.)
(2) Set the following network parameters using the OSD menu. (See page 53.)
• DHCP client ON/OFF, IP address, subnet mask and default gateway.
(3) Set the IP address described above and the port number (63007 or 3007) using the application program of your computer to
perform the socket communication.
(4) Send the same control command as that for RS-232C via TCP/IP socket communication.
(5) Check the return command sent from the monitor. When it is received successfully, the setting is completed.