– 10 –
Air scroll
Flap moves up and down
continuously.
•
If the room temperature control (thermostat) switches to the heating mode or if the defrosting operation is on, the blow flap changes automatically to a horizontal
position.
•
If the heating operation has just started and the room temperature is still low, it may take a while before the flap moves to the above sway operation angle.
•
The flap may stop at the tilted down-blow position during the “sway operation” in the heating mode.
NOTE
MEMORY FLAP (FLAP STOPPED)
Adjusting left/right air flow direction
CAUTION
Please stop the air conditioner when
adjusting the air flow direction.
When you press the AIRFLOW button once while the flap is operating, it stops swinging at an
angle.Since this angle is memorized in the micro-computer, the flap will automatically be set at this
angle when the next operation is started.
•
Recommended angle of the flap when stopping
Emergency run operation
•
The ON/OFF button on the unit operates ON/OFF temporarily when the remote control is not used.
Operation program
•
OPERATION MODE
:
AUTO
•
FAN SPEED
:
AUTO
•
AIR FLOW
:
AUTO
•
Operation starts by pressing the ON/OFF button; it stops if you press the button again.
Unit ON/OFF button
DANGER
•
Avoid constant airflow to the body for hours on end.
CAUTION
•
When in COOL or DRY operation, do not operate for hours on end with the air
flow blowing straight down. Otherwise, condensation may appear on the outlet
grill and drip down.
•
Do not try to adjust the flaps by hand, as the control angle may change or the flap
may not close properly.
Air flow direction adjustment procedure
HEAT
(Horizontal
blowing)
(Slant forward
blowing)
COOL, DRY
Adjust the direction by moving the left/right
air flow fin by hand.
SWING FLAP
Thick line
: moves quickly
Thin line
: moves slowly
Thick line
: moves quickly
Thin line
: moves slowly
Stops at this position
for 5 seconds.
Stops at this position
for 5 seconds.
In COOL and DRY operation
In HEAT operation
Adjusting up/down air flow direction
■
Up/down direction can be adjusted with the AIRFLOW button on the remote control. Each time when you press this button the mode changes
as follows:
Change to AIRFLOW mode.
(Air scroll)
(SWING)
(flap stopped)
RWA012A226C_En
04.11.10, 4:06 PM
10
Summary of Contents for SCM45ZD-S
Page 42: ......
