Mitox 26B-SP, Operator'S Manual, Page: 13 / 32

26B-SP / 28BV-SP
13
Original Instructions Version June 17
IMPORTANT To avoid breaking the starter rope, do not pull the whole length of it or let it slide
along the edge of the rope guide hole. Release the starter gradually, to avoid letting it fly back
uncontrollably.
5a. Move the choke lever (2) to the run position.
6. Pull the starter rope again, fully squeezing the throttle (4) until the engine starts.
7. Let the engine run at idle for at least 2–3 minutes before using the machine.
IMPORTANT If the starter rope is pulled repeatedly with the choke on, it may flood the engine
and make starting difficult. If you happen to flood the engine, repeat the hot start procedure a
few times to eliminate any excess fuel.
3.1.2 Hot starting
When hot starting (immediately after stopping the engine), follow the procedure indicated above
in points 1 - 4 - 5 - 6.
3.2 ADJUSTING THE SPEED (Fig. 4)
Rotor rpm must be proportionate to the type of work and regulated by the throttle trigger (4)
located on the upper hand grip. The throttle trigger can be held in any required position by en-
gaging the cruise control lever (5).
3.3 STOPPING THE ENGINE (Fig. 4)
To stop the engine:
– Return the cruise control lever up (5).
– Release the throttle control (4).
– Set the switch (1) to position «O».
Fig.4