mitko DOME M5, Manual

Page: 4 / 28

4/28
ENGLISH
Wind
speed
[ km/h]
Ground
Weight / Anchor for each
foot
Anchor for rope mounted
under
‡
45°
< 50
Concrete
substrate
2× 27,5 kg ** –
Ground
substrate
3× steel anchor 34 cm *
Twisted steel anchor,
length 34 cm *
50–100
Concrete
substrate
3× standard segment anchor
HSA-R M6 × 85 30/40 ***
Sleeve anchor (closed
eyebolt) HLC-EC 16 × 100 ***
Ground
substrate
3× steel anchor 34 cm * Steel anchor length 45 cm
* Tent’s standard equipment
** Non-standard tent equipment accessory
*** Art. offered by Hilti (Poland) Sp. z o.o. https://www.hilti.pl/)
Table 1. Ways to anchor a tent
snow gathering on the roof, if the layer of the snow is 2 cm or higher.
4. Water lingering on the roof should be immediately removed.
5. With recurring gusts of wind, anchoring should be checked systematically.
6. Producer declares that the statistic calculations for the tent were carried out in
accordance with PN-EN 13782:2005 norm concerning Temporary objects, tents,
safety. The tent may be used in a zone with wind up to 28 m/s (100 km/h) provided
it is protected against wind gusts as described in table no. 1. During strong wind the
product should be folded immediately. Mechanical damage resulting from failure to
follow the above recommendations are not covered by the warranty.
ASSEMBLY SEQUENCE
1. Take out the components of the tent from the bag and lay on even ground.
2. The profiles are tied with cords to keep them together.
3. Connect into arches the profiles which make the entrances stiff. Connect into arches
the profiles of the load-bearing structure.
4. Insert the profile of the load-bearing structure into the 5-way connector.
5. Lift the frame (we recommend using a ladder). Release buttons will place
themselves in profile holes.
6. Set the profiles on the other feet.
7. Set the profiles that make the entrance stiff on the side tubes of the foot.